HOFTRONIC™ - Wireless LED dimmer set

Wireless dimmer set
Stylish, tightly designed wireless pushbutton led dimmerset with a lot of possibilities and can dodge almost every LED spot.
This dimmer can be confirmed in a number of ways:

• On a construction box.
• On a smooth wall with a tape clip (supplied).
• Wood or plaster wall with screws.

It is also possible to replace the outside or outer edge with your standard cover material. This dimmer fits almost everywhere.

Compatible cover material:

You will need a receiver for this dimmer: This is supplied with this set.

This LED dimmer uses a button cell battery: 3V CR2430 (included)
What is included in this set:

• Pressure dimmer module, transmitter.
• Beautiful glass outer rim with white background
• Wallpaper.
• Slice 3M.
• 2 small screwdrivers.
• Battery: 3V CR2430
• Operating Instructions
• 1 receiver with 2 short cords (approx. 15 cm) to connect to your 230 Volt.
  and two short wires (about 15 cm) to connect to your 230 volts of your transformer / driver / LED spot etc..

 
Pay attention! Before use remove the plastic strip underneath the battery.

Receiver:
Receiver for pressure dimmer PL-SR-2833K1
Easy to install receiver for the above-mentioned pressure dimmer.

Due to the small size of this receiver, he is installed in many places. This way (almost) always fits above the ceiling, in most welding boxes, wall boxes, and so forth.

Easy to install:
You place it between your 230 volt connection and the 230 volt connection of your transformer / driver etc.
Get 1 x on your lights and pressure dimmers and you can dow almost every LED spot.

What will be delivered:
1 receiver with 2 short cords (approx. 15 cm) to connect to your 230 Volt.
And 2 short cords (approx. 15 cm) to connect to your 230 volt of your transformer / driver / led spot, etc.